Complex Mixed Signal Board Design Course (Ethernet PHY, STM32F407, STM32F103, CH340C, DAC/MIC, 24Bit ADC, 36W Drivers)
What you'll learn
- How to Extract Components information from Requirement Sheet
- Selection of Component for Example: Ethernet PHY, Micro-Controller, Motor Driver, Mosfets, ADC, ADC/DAC, MIC etc.
- How to Draw a Complex Schematic Block and Its Power Budget Diagrams
- What are Differential pairs, USB2.0, I2Cs, UART/USART, CAN, MII/RMII, I2S and many more interfaces
- EMI & EMC decisions for a Complex Mixed Signal Schematic Design
- How to Create Design Rules Decision for Complex Mixed Signal Board
- Layer Stack-Up Design (4L/6L/8L/12L) and Field Solver Simulation
- How to Define Board shape and Rigid-Flex PCB Board
- Components Placement planning for a Complex Board and its Execution
- How to Layout a Complex Board with more than 10,000 interconnects, and Layout Optimization
- Power Distribution Network (PDN Analysis) and How to read its Report + Resolve Issues
Requirements
- For this course Student should have "Altium Designer" Installed on their PC / Laptop
- Student Should have knowledge of Basic Electronics.
- You do not need any prior knowledge of "Altium Designer" because we'll going to do everything from scratch.
Description
I have Divided this course into 4 Major Sections:
- 1st Section is Selection of Each Components whatever Going inside the Schematic.
- 2nd Section is Schematic Designing by Reading Datasheets.
- 3rd Stack-up 4L/6L/8L/12L, Components Placement Planning and Execution.
- 4th Inter Block and Intra Block Layout Planning and Execution.
You will also learn some Basic Blocks as well:
- Pre-Schematic Design Blocks (Block Diagram and Power Budget)
- Layer Stack-up Selection and Rules for Defining any Stack-up
- Different Grounding Techniques( Signal Grounding, Earth Grounding, Chassis Grounding)
- How to Create a RIGID-FLEX PCB and its Stack-up
- How to do Pin-mapping using Cube-MX tool.
- Power Distribution Network Analysis (PDN Analysis) of any PCB.
and many more things. - Ferrite Bead, ESD Diodes, and Magnetic Application and their selection.
- How to do Placement and Layout Planning on Microsoft-Paint.
and many more....
Major Controller used in this course are STM32F407XX, STM32F103XX apart from that we used PHY, and Some other sensors and ADC/ DAC as well.
Who this course is for:
- People who have no experience with Hardware design and want to learn it
- People Who want to Learn Complex Mixed Signal Board Design
- People who want to learn PCB designing
- People who want to Learn How to Select Components out of millions of chip available
- People Who wan to Learn How Create a Board on Altium Designer.
- People who want to enhance their Electronic Hardware Designing Skills.
